Knots

I have a 2004 Scag TT model STT61A-27CH with a 61inch deck that has a deck adjustment issue. Page 24 of the owners manual says" loosen the serrated flange hex nut and move the bolt up or down to adjust the deck". As near as I can tell, there is no serrated flange hex nut and no slot to move it up or down.
Has anyone else run into this problem while trying to level the deck left to right?
Any info would be greatly appreciated. Need help!

Thanks

Knots

FOR LOVERS of LAWNBOYS

Thought I'd pass this on, you have to scroll down a bit on the posting .

http://ift.tt/2uaW3j5

FOR LOVERS of LAWNBOYS

Repairs HRX217HYA-How2 Remove Adjuster Arm on Rear Axle?

Can someone tell me how to remove the adjuster arm on the rear axle of my HRX217HYA so I can lube the bushing that's shown behind it on the attached diagram?

It appears that the adjuster arm simply slides off the axle, after removing the wheel, wheel cover, circlips and a couple of washers.

I tried prying it off by placing a flat tip screwdriver between the arm and the Nexite deck, but it won't budge.

Any help on this would be appreciated.

Attached Images

• FullSizeRender.jpg (137.0 KB)

Repairs HRX217HYA-How2 Remove Adjuster Arm on Rear Axle?

Need Walker help

Hello, everyone! I have an older walker MTGHS 48". I am in need of a new PTO shaft (tube). I haven't been able to find a replacement. Mine is the rectangular shaft and not the spline like the newer models. Any help would be much appreciated ,Thank you.

Need Walker help

need to replace 20 year old JD gt275

The electric clutch has gone out on my 1998 GT275. T replace it, $400 for clutch and am told nearly that for labor. Engine is in great shape and so is deck. Not sure whether to just get a new one or fix. Health isn't the best so that has to be a factor. Don't want to spend $800 and something else go wrong. Looking to spend $3k max. Another JD or a Hustler Zero turn? Thoughts?

need to replace 20 year old JD gt275

lx 173 electronic clutch problem?

Went to mow this morning and when I engaged the electronic clutch for the blades the engine acted like I'd turned off the key.
I thought the electronic clutch went bad so I replaced it and got the same problem.
Then replaced the engagement switch and same problem, it kills the engine.
Also engaged the switch without it hooked to the clutch,same problem.................
traced the wires looking for a short but couldn't find one.

I'm at a loss to what ta do now.............:ashamed:

Any ideas to the next step?

lx 173 electronic clutch problem?

Kohler engine swap

I have a 2006 Troy Bilt super bronco with a Kohler 19 hp courage with a cracked block. Any info on what I can swap this out with

Kohler engine swap