Here is what I have:
5091000 Snapper Fast Cut ZT18440KH, 18HP Zero-Turn Rider with 44" Mower, I know this because I used to have a basic manual.
It has a Kohler motor on it. I have to assume it's an 18HP because all of the Kohler Identification that I know to look for is gone.
Here are a few pics:
IMG_9188.jpg
IMG_9190.jpg
IMG_9189.jpg
My issue is electrical. And it has to be something related to the charging system. Here is my reasoning:
Just bought a new battery, (the old one died VERY quickly and I just thought perhaps we left the key on). The new battery starts the mower just fine. Twenty minutes into mowing the motor just shuts off. In this case I was able to fire it up for about 20-30 seconds after turning off the blades and letting it sit for a minute. But then it just shuts off again. Leave it sit for 30 minutes and it will run for 2-3 minutes now.
So, I'm capable of replacing components, but my issues are:
1. I can't figure out EXACTLY which Kohler motor to buy components for since my Kohler ID tag is gone.
2. I am unsure of which electrical components I should replace, and in what order?
3. Does anyone know of some good videos or tutorials on how to replace these components?
Hope y'all can help out!
Thanks!
5091000 Snapper Fast Cut ZT18440KH, 18HP Zero-Turn Rider with 44" Mower, I know this because I used to have a basic manual.
It has a Kohler motor on it. I have to assume it's an 18HP because all of the Kohler Identification that I know to look for is gone.
Here are a few pics:
IMG_9188.jpg
IMG_9190.jpg
IMG_9189.jpg
My issue is electrical. And it has to be something related to the charging system. Here is my reasoning:
Just bought a new battery, (the old one died VERY quickly and I just thought perhaps we left the key on). The new battery starts the mower just fine. Twenty minutes into mowing the motor just shuts off. In this case I was able to fire it up for about 20-30 seconds after turning off the blades and letting it sit for a minute. But then it just shuts off again. Leave it sit for 30 minutes and it will run for 2-3 minutes now.
So, I'm capable of replacing components, but my issues are:
1. I can't figure out EXACTLY which Kohler motor to buy components for since my Kohler ID tag is gone.
2. I am unsure of which electrical components I should replace, and in what order?
3. Does anyone know of some good videos or tutorials on how to replace these components?
Hope y'all can help out!
Thanks!
Electrical help/suggestions for my Snapper ZTR 44" w/ a Kohler 18 HP
Aucun commentaire:
Enregistrer un commentaire